Rowlett · Dallas County · Open 24/7 (972) 903-8224
Fixtures

Faucet & Sink Repair in Rowlett

A dripping faucet is easy to put off, right up until the drip adds up on the water bill or the worn cartridge finally fails completely. Rowlett Pro Plumbing repairs and replaces kitchen and bathroom faucets, sink supply lines, and shutoff valves across Rowlett.

Plumber repairing a kitchen faucet

Common Calls

  • ✓Dripping faucet, almost always a worn cartridge, washer, or O-ring.
  • ✓Leak under the sink at a supply line or shutoff valve connection.
  • ✓Low water pressure at one fixture specifically, often a clogged aerator.
  • ✓Faucet handle loose, hard to turn, or leaking at the base.

A drip today is a bigger leak eventually. Get it fixed now.

☎ Call (972) 903-8224

Repair Or Replace

Most faucet drips are a worn internal cartridge, and on a name-brand faucet that is usually a straightforward part swap rather than a full replacement. A faucet from a builder-grade, no-name brand, or one that is already 15-plus years old often does not have replacement cartridges readily available, and full replacement ends up being the more practical fix.

An under-sink leak at a supply line or shutoff valve is almost always a fitting or valve replacement rather than anything to do with the faucet itself, and it is usually a quick, inexpensive fix once the actual connection is identified.

Typical Cost

Cartridge or washer replacement$140 to $280
Supply line or shutoff valve replacement$150 to $300
Full faucet replacement, standard unit$275 to $550 installed

Hard Water And Faucet Wear

North Texas water is moderately hard, and mineral scale builds up inside a faucet's internal cartridge and around the aerator screen faster here than it would on genuinely soft water. That buildup is a common reason a faucet starts feeling stiff, drips even after a repair, or loses pressure at just that one fixture while the rest of the house is fine.

A quick aerator cleaning is worth trying before assuming a bigger problem: unscrew the aerator at the tip of the faucet, soak it in vinegar for a few minutes, and rinse. If pressure improves, that was the whole issue. If it does not, the cartridge or the supply line itself is the more likely cause.

Kitchen Versus Bathroom Faucets

A kitchen faucet works harder than a bathroom faucet, more daily cycles, more temperature swings, and often a pull-down sprayer hose with its own wear points. That is why a kitchen faucet's internal parts tend to wear out first even on a newer home, while a bathroom faucet in the same house can go years longer before needing attention.

Codes This Work Follows

Supply line and fixture work follows the Uniform Plumbing Code (UPC) and International Plumbing Code (IPC) the Texas State Board of Plumbing Examiners adopts statewide, including correct backflow prevention at fixture connections.

Common Questions

Why does my faucet still drip after I replaced the washer myself?+

A drip that continues after a washer swap usually means the actual worn part is the cartridge or the valve seat, not the washer, or the replacement part was slightly the wrong size for that specific faucet model. A technician can confirm the exact part needed rather than guessing through a second DIY attempt.

Can you match my existing bathroom or kitchen faucet finish?+

In most cases yes, for common finishes like chrome, brushed nickel, and matte black. For a discontinued or unusual finish, we will let you know upfront if an exact match is not realistic so you can decide before we start.

Is it worth repairing an old faucet or just replacing it?+

If the faucet is a recognizable name brand and the body itself is in good shape, a cartridge swap is almost always cheaper and faster than a full replacement. Once a faucet is old enough that the manufacturer no longer stocks parts for it, or the finish has worn through in spots, replacement usually makes more sense than chasing down an obsolete part.

Can a single-handle faucet be repaired the same way as a two-handle one?+

The repair concept is the same, isolate the water, replace the worn internal part, but the parts themselves differ. A single-handle faucet usually has one cartridge controlling both hot and cold, while a two-handle faucet has a separate stem or cartridge for each side, which can mean one side wears out well before the other.

Do you carry parts for older or discontinued faucet models?+

We carry the common current cartridges and stems for major brands, and can usually source an older or less common part ahead of the visit once you tell us the brand and rough age of the faucet on the phone.

Same-day faucet and sink repair, most calls.

☎ Call (972) 903-8224

Leaking Or Dripping?

Same-day faucet and sink repair anywhere in Rowlett.

☎ Call (972) 903-8224

Dripping Faucet?

(972) 903-8224
☎ Call Now
  • Same-day repair
  • Finish-matched replacement
☎ Call (972) 903-8224